Toll Free (800) 363-8571

  


Technical Notes from Dr. Mel Giberson, PH.D., P.E.  -  TRI President 

December 1, 1998

“It is cheaper to buy power than to make it” is being re-evaluated by electric utilities across the U.S.

Last summer showed that utilities purchased power at over 100 times normal generation costs.

TRI Resolution of Turbine High Amplitude Rotor Vibration Problem

Problem and Solution:

A utility has several identical 190 MW, 3600 RPM large steam turbine-generators with excellent heat rates and a vibration problem at certain loads (certain control valve positions). With the original bearings, it is not possible to balance the turbine rotors at all loads. The typical solution has been to operate the units at fixed loads near maximum generation. Because other units have to be turned down further or shut off at night, the resulting system costs are relatively higher. In 1995, TRI designed, built and installed a set of TRI Align-A-Pad® tilting pad bearings for the HP and IP turbines of one of these units. The rotorbearing dynamic characteristics were changed so that the turbines can now be balanced at all MW loads. The new system exhibits lower vibration and reduced turbine losses. The system is now run by the Automatic Generation Control (AGC) and the overall average generation cost for the system has been reduced.

As this electric utility re-evalulates power sourcing and costs, units are being retrofitted with TRI AlignA-Pad bearings. Contact TRI with a description of your turbinegenerator rotor vibration or bearing problems, and TRI will be pleased to provide you with a proposal for resolution. TRI offers performance warranties in most cases.

 

TRI Replacement of Older Fluid Drive Impellers and Runners Damaged by High Cycle Fatigue

Problem and Solution:

Most fluid drives installed in the U.S. were put into service in the 1960s. With increasing service life, fluid drive impellers/runners are beginning to fail via endurance limit problems. Also known as High Cycle Fatigue (HCF), an impeller/runner blade fails due to blade passing excitation frequencies that match the blade natural frequencies. The problem arises more when units are used in sliding pressure applications because the output shaft speed varies widely. Flaws in the material or other manufacturing defects can exacerbate HCF problems.

TRI has solved the HCF problem by manufacturing new impellers and runners using improved blade shapes, materials, and manufacturing techniques. With increasing probability of HCF failure of older units due to extended time in service, and because impellers and runners have long lead times, TRI recommends a spare rotating element or a complete spare fluid drive for critical service applications. If not possible, TRI recommends purchasing spare impellers and runners. Such spares permit a fluid drive assembly to be rebuilt quickly, minimizing the time that a utility is exposed to the prospect of purchased power at exorbitant rates.

For the most demanding applications, TRI manufactures impellers and runner with integral reinforcing rings, US patent 5,331,811.

 

 

  • Contact TRI for a review of your existing, proposed or conceptual fluid drive applications. 
  • Contact TRI for spare parts, repowering/upgrading, new fluid drives to improve efficiency of fans or BFPs. 
  • Contact TRI for replacement of electronic variable frequency drives with more reliable fluid drives.

Updated and expanded catalogs of TRI products and services are now available.


Please visit us at these Exhibitions:
Power Generation International Conference Orlando,  FL December   9, 10, 11, 1998
Energy Generation Conference Bismarck ND January 26, 27, 28, 1999
Electric Power ’99 Exhibition Baltimore, MD April 20, 21, 22, 1999

 

Please help us update our database: If the addressee has moved, should be deleted, or others should be added, please advise.  Thank you 

 

More Tech Notes

Sign up to get future Tech Notes in your email